Internet and Businesses

Netgear EX7300 Randomly Drops Connection. How to Fix It?

Netgear EX7300 WiFi range extender is one of the advanced technology-based network devices that blanket almost every corner with strong wireless signals. Even after performing Netgear EX7300 setup successfully sometimes range extender behaves mischievously. As a result, Netgear EX7300 randomly drops connection.

Why this happen? How to fix Netgear EX7300 WiFi range extender randomly internet drops connection error? Let’s discuss it.

Mechanism of WiFi Range Extender – Mywifiext

WiFi range extender acts as a bridge between the existing home WiFi router and the connected WiFi-enabled devices. It captures the wireless signals from the router and rebroadcast the signals further in boosted form.

Before we shed some light on how we can fix Netgear extender keep dropping internet connection, we have to be sure that your Netgear extender is configured properly. So, consider the below-mentioned two Netgear extender setup methods.

Methods to Setup Netgear Extender

Method 1: Connect extender to router via WPS

This is no time Netgear EX7300 setup method. All you have to place your WiFi extender in the same room as your existing router during the setup process. And then, press the WPS button present at the back or side panel of your extender device. Wait for a few minutes, let the power LED turns solid green. That’s it! Your Netgear EX7300 extender has configured successfully.

Method 2: Configure your WiFi extender via hardwire

In this method, you have to connect your Netgear extender to router via an ethernet cable. Connect your computer to home network. Run any web browser and type 192.168.1.250 IP address. And then, hit the ‘Enter’ key. You land on the Netgear extender login web page. Enter the login details and configure your device as per your requirements.

Now, as you are well aware about the Netgear extender setup methods. Let’s steps ahead and try to fix Netgear extender connectivity issues.

Methods to Fix Netgear EX7300 Randomly Drops Connection Error

Step 1: First of all, plug-in your WiFi range extender to an electric power outlet.

Step 2: Then, try to connect your WiFi extender to router wireless or with the help of an ethernet cable. Meanwhile, try to connect your device to the extended network named like Netgear_EXT.

Step 3: Run any web browser and go to mywifiext.net web address.

Step 4: You will be prompted to Netgear extender GUI-based interface.

Step 5: Enter the login credentials i.e. username and password in the appropriate fields. Click on the ‘Log In’ button.

Step 6: Visit the firmware section. Click on the ‘Update’ button to check if any latest firmware version update is available or not. If available, then try to upgrade your Netgear extender firmware version.

Step 7: If still the problem persists, then try to reset your WiFi range extender with the help of a paperclip.

Step 8: Once your WiFi extender reset successfully, then retry to configure it again.

Conclusion

Does this article help you out?

Please let us know. If still you are still facing the same issue, then get in touch with us via comments. We respond you back with some best solutions.

Related Articles

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button